| Section | ||||||||||||||||||||
|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Locations Management
For the locations management go to Organization → Locations. Here it will be shown a list of all the locations of the organization. A location is defined by a gateway with a SiteController running.
The list shows the following information of each site:
- Connection status: Green if is currently connected, yellow if it is not.
- Name: The location name. By default all new locations will have the name test_SERIAL using the serial name configured on the Site Controller.
- Type: The type of site. There are two possible types;
- PRODUCTIVE: Sites that are consider in production, and are shown in all the lists and reports
- TEST: Sites which are not considered to be fully functional, and are only shown on this list. The are not shown in any other part of the system
- Sensor Template: The assigned sensor template of the site, with a direct link to it
- System Config: The assigned System Config of the site, with a direct link to it
- Actions: Which are:
- Edit: To edit the site basic information (see next section)
- Floor Plan: If a floor plan for the site was loaded, it will take the user to it.
- Deployments: A direct link to the deployments page for this site
- Sensor Template / Location Parameters: A direct link to edit the site template assigned to the site, to customize only for this locations (the changes will not be applied to other sites that use the same site template).
- System Config / Location Parameters: A direct link to edit the system config template assigned to the site, to customize only for this locations (the changes will not be applied to other sites that use the same system config template).
Each site
User Management
Timeperiods Creation
...