...
...
...
...
...
...
Section | |||||||||||||||||||||||||||||||||
---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|---|
|
Configure Access to the azeti Engine
...
Code Block | ||
---|---|---|
| ||
[ExternalBroker] host = azetibroker02broker.azeti.net port = 18838883 ... user_id = broker_username@example.com password = VerySecretPasswordGoesHere organizationShortName = azeti tls_enable = FalseTrue ... |
Starting the system
The Site Controller is controlled by the central start script.
Start the Site Controller, it will start the mosquitto automatically if necessary
Code Block root@ubuntu:~# /opt/azeti/SiteController/run_SiteController.py start
- Verify that everything runs fine after you started the Site Controller. Running modules will be highlighted green and labelled as running with. The status command also shows your configured broker username and the destination URL, double check to make sure these are correct.
Code Block | ||
---|---|---|
| ||
root@raspberrypi /opt/azeti/SiteController # ./run_SiteController.py status Time zone set to: Etc/UTC Serial of this installation: raspi-test-sebastian Main version of this installation: 1.2.0 Host type: RasPi External Broker set to: azetibroker02.azeti.net:1883, TLS disabled Checking installation ... OK: Integrity check passed. OK: Module mosquitto is running with PID (2175) OK: Module Watchdog.py is running with PID (2355) OK: Module cloudConnector.py is running with PID (2388) OK: Module HD2CloudExporter.py is running as sub thread of cloudConnector.py with PID (2388) OK: Module ConfigProvider.py is running with PID (2489) OK: Module RawResultsDeMux.py is running with PID (2595) OK: Module CalibResultsEvaluator.py is running with PID (2609) OK: Module JobProcessor.py is running as sub thread of cloudConnector.py with PID (2388) |
Stopping the system
This command stops all site controller modules.
Code Block |
---|
root@raspberrypi /opt/azeti/SiteController # ./run_SiteController.py stop |
Access the new Location in azeti Control Panel
...