Here is a list of recommended sensor to use with the Azeti solution. This list is only a recommendation, as any sensor that is compatible with the protocols supported (Modbus TCP, RTU, SNMP) can be used.
Supported Protocols and Types
A wide variety of sensor and I/O protocols are supported and any standard device that complies with these standards is consider compatible. I/O Modules, such as the Advantech and B&R X20 extend the solution with hundreds of different input and output variations as these device translate from, e.g. 4-20mA or sink input into MODBUS TCP. See the vendor list and their catalogues for reference.
- MODBUS TCP
- MODBUS RTU/ASCII
- Digital Inputs
- Sink/source inputs (dry/wet contacts)
- Relay outputs
- Analogue Inputs
- UDP Data
- TCP Sockets
Input/Output Modules
Modbus RTU
Vendor | Device | Comment | Connects via | Power |
Advantech | ADAM-4051-BE | 16 Digital Inputs | RS485 MODBUS | DC 24V |
Advantech | ADAM-4117-AE | 8 Analogue Inputs | RS485 MODBUS | DC 24V |
Advantech | ADAM-4150-AE | 7 Digital Inputs, 8 Outputs | RS485 MODBUS | DC 24V |
Advantech has many more modules with different configurations of inputs and outputs. All of them should be compatible. For more information go here
...
Info |
---|
The modular I/O approach brings the best cost/performance ratio and saves resources for smaller devices compared to multi-MODBUS setups. |
Vendor | Device | Comment | Connects via | Power | Link |
B&R Automation | X20 Series | Modular I/O system offering modules for many combinations of inputs/outputs, AC meters and condition monitoring. | Ethernet | DC 24V | X20 System |
Recommended B&R X20 configuration
The following combination fulfills most common requirements.
Module | Description |
---|
X20BC0087 | MODBUS TCP |
X20PS9400 | Power Supply |
X20DI9372 | 12x Digital Inputs |
X20DO6639 | 6 Relays, 240 VAC |
X20AI4622 | 4x Analog Inputs, 4-20MA or 0-10V |
X20AP3131 | AC Meter, 480 VAC, 50/60 Hz, 5A sec. current |
Single modules
Vendor | Device | Comment | Connects via | Power |
Advantech | ADAM-6251-AE | 16 Digital Inputs Ethernet Module | Ethernet | DC 24V |
Advantech | ADAM-6217-AE | 8 Analogue Inputs Ethernet Module | Ethernet | DC 24V |
Advantech | ADAM-6250-AE | 7 Digital Inputs, 8 Outputs, Ethernet Module | Ethernet | DC 24V |
Advantech has many more modules with different configurations of inputs and outputs. All of them should be compatible. For more information go here
Modular Modbus TCP
Vendor | Device | Comment | Connects via | Power |
Advantech | ADAM-5000/TCP-AE | 8-slot Distributed DA&C System Based on Ethernet | Ethernet | DC 24V |
Advantech | ADAM-5051-AE | 16-channel Digital Input Module with RoHS | Ethernet | DC 24V |
Advantech | ADAM-5017P-AE | 8 Analogue Inputs Ethernet Module | Ethernet | DC 24V |
Advantech | ADAM-5050-A2E | 16-Ch Universal DI/O Module | Ethernet | DC 24V |
Power Sensors
AC Sensors
Vendor | Device | Comment | Connects via | Power | Number of Output Parameters | Output Parameters |
Elkor | WattsOn-1100-MSCT2-600A | AC Power Meter | RS485 MODBUS | DC 24V | 50 | - Voltage (A, B, C, Avg, AB, AC, BC, Avg)
- Current (A, B, C, Avg)
- Active Power (A, B, C, Total) - Bi-directional
- Apparent Power (A, B, C, Total)
- Reactive Power (A, B, C, Total) - Bi-directional
- Power Factor (A, B, C, System) - Bi-directional
- Frequency
- Import/Export Energy (A, B, C, Total)
- Inductive/Capacitive Energy(A, B, C, Total)
- Apparent Energy (A, B, C, Total)
- Total Demand Power (W)
|
Elkor | MSCT2 | Current transducer for WattsOn, one per phase needed | To WattsOn (analog) |
|
| 1 | Current |
Elkor | i-Snail-S | Current Switched Sensor, monitoring on/off state of a device | Digital Input |
|
| 1 | Go/No-Go Signal |
Elkor | i-Snail-VC | AC current sensor | Analog Input |
| DC Sensors
Vendor | Device | Comment | Connects via | Power | Number of Output Parameters | Output Parameters | Comments |
CE-Transducers | AD11B-34GS4-1.0/0-250A*0-65V | DC mulit parameter monitoring (U,I,P,KWh) | RS485 MODBUS | DC 24V | 1 | Voltage |
Wrong devide numer? Should start with CE |
|
CE-Transducers | CE-AU11-34MS3-0.2/0-65V | 1-element DC Voltage Meter | RS485 MODBUS | DC 24V | 1 | Voltage |
Battery Sensors
Vendor | Device | Comment | Connects via | Power | Number of Output Parameters | Output Parameters |
Huasu | H3G-TA12V-A | Battery Monitoring System: 12V monitoring | RS485 MODBUS | DC 12V | 1 | Voltage and temperature |
Huasu | CTB-485-A | Battery Monitoring System: UART to RS485 | RS485 MODBUS | DC 12V | 1 |
|
Huasu | TC-500-A | Battery Monitoring System: Current Module | RS485 MODBUS | DC 12V |
| Current and temperature |
Huasu | CS-A0 | Battery Monitoring System: Current Transducer | RS485 MODBUS | DC 12V |
|
|
Other Sensors
Enviromental
Fuel
Vendor | Device | Comment | Connects via | Power | Number of Output Parameters | Output Parameters |
AST Sensors | AST 4510 - Pressure Sensor | Fuel level Sensor | Analog Input | DC 24V | 1 | (indicate Pressure) |
Holykwell | HPT604 | Fuel level Sensor | Modbus RTU | DC 24V | 1 or 2 | - Pressure
- Temperature (optional)
|
Access Control
Vendor | Device | Comment | Connects via | Power | Number of Output Parameters | Output Parameters |
HIDGlobal | Proxpro 5355 | Keypad HIDGlobal Proxpro 5355 | Wiegand | DC 10-28.5V |
| |
|
|
Infranet | WTSC-485 | WTSC-485 Wiegand to RS-485 Converter (for Keypad) | RS485 MODBUS | DC 24V |
| | ...
|
|
|
SimonsVoss | Electronic Padlock | Wireless Electronic Padlock | Wireless |
|
|
|
SimonsVoss | Keypad | Wireless Keypad | Wireless |
|
|
|
SimonsVoss | Gateway Node | Gateway to connect via wireless to the padlock and keypad | Ethernet | DC 24V |
|
|
Providers
| Ekor | | | Buying through the webpage | | |